DHCP 服务器如何知道我的 IP 地址？

Question

17号、22号、200号、390号、531号、535号数据包的目的地应该是广播消息，但为什么它们是我的IP地址？注意我已经释放了我的IP。

Answer 1

只有在特定情况下才应广播 DHCPOFFER 和 DHCPACK。在大多数情况下，这些应该被单播回请求主机。

服务器知道请求主机的 MAC 地址，因此除非请求主机在 DHCPREQUEST 中设置了广播位，否则帧将被单播回请求主机。

见RFC 2131, Dynamic Host Configuration Protocol:

Normally, DHCP servers and BOOTP relay agents attempt to deliver DHCPOFFER, DHCPACK and DHCPNAK messages directly to the client using unicast delivery. The IP destination address (in the IP header) is set to the DHCP 'yiaddr' address and the link-layer destination address is set to the DHCP 'chaddr' address. Unfortunately, some client implementations are unable to receive such unicast IP datagrams until the implementation has been configured with a valid IP address (leading to a deadlock in which the client's IP address cannot be delivered until the client has been configured with an IP address).

A client that cannot receive unicast IP datagrams until its protocol software has been configured with an IP address SHOULD set the BROADCAST bit in the 'flags' field to 1 in any DHCPDISCOVER or DHCPREQUEST messages that client sends. The BROADCAST bit will provide a hint to the DHCP server and BOOTP relay agent to broadcast any messages to the client on the client's subnet. A client that can receive unicast IP datagrams before its protocol software has been configured SHOULD clear the BROADCAST bit to 0. The BOOTP clarifications document discusses the ramifications of the use of the BROADCAST bit [21].

-和-

In the case of a client using DHCP for initial configuration (before the client's TCP/IP software has been completely configured), DHCP requires creative use of the client's TCP/IP software and liberal interpretation of RFC 1122. The TCP/IP software SHOULD accept and forward to the IP layer any IP packets delivered to the client's hardware address before the IP address is configured; DHCP servers and BOOTP relay agents may not be able to deliver DHCP messages to clients that cannot accept hardware unicast datagrams before the TCP/IP software is configured.

To work around some clients that cannot accept IP unicast datagrams before the TCP/IP software is configured as discussed in the previous paragraph, DHCP uses the 'flags' field [21]. The leftmost bit is defined as the BROADCAST (B) flag. The semantics of this flag are discussed in section 4.1 of this document. The remaining bits of the flags field are reserved for future use. They MUST be set to zero by clients and ignored by servers and relay agents. Figure 2 gives the format of the 'flags' field.
                                 1 1 1 1 1 1
             0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
            +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
            |B|             MBZ             |
            +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

            B:  BROADCAST flag

            MBZ:  MUST BE ZERO (reserved for future use)

            Figure 2:  Format of the 'flags' field

DHCP 服务器如何知道我的 IP 地址？

How does the DHCP server know my IP Address?

ip

networking

dhcp