Arduino 与 HC-05 连接时，串行通信无法正常工作

Question

我是 Arduino 编程新手。

这段代码工作正常。它提供正确的输出并且运行良好。但我想自动编写命令而不用重复输入。

#include <SoftwareSerial.h>

SoftwareSerial BTSerial(10, 11); // CONNECT BT RX PIN TO ARDUINO 11 PIN | CONNECT BT TX PIN TO ARDUINO 10 PIN

void setup()
{
  pinMode(9, OUTPUT);  // this pin will pull the HC-05 pin 34 (key pin) HIGH to switch module to AT mode
  digitalWrite(9, HIGH);
  Serial.begin(38400);
  Serial.println("Enter AT commands:");
  BTSerial.begin(38400);  // HC-05 default speed in AT command more
}

void loop()
{
  if (BTSerial.available()) {
    Serial.write(BTSerial.read());
  }
  if(Serial.available()){
    BTSerial.write(Serial.read());
  }
}

所以我尝试在上面的代码中进行以下更改，但我无法收到任何响应。

#include <SoftwareSerial.h>

SoftwareSerial BTSerial(10, 11); // CONNECT BT RX PIN TO ARDUINO 11 PIN | CONNECT BT TX PIN TO ARDUINO 10 PIN

void setup()
{
  pinMode(9, OUTPUT);  // this pin will pull the HC-05 pin 34 (key pin) HIGH to switch module to AT mode
  digitalWrite(9, HIGH);
  Serial.begin(38400);
  Serial.println("Enter AT commands:");
  BTSerial.begin(38400);  // HC-05 default speed in AT command more
  BTSerial.write("AT");
}

void loop()
{
  if (BTSerial.available()) {
    Serial.write(BTSerial.read());
  }
}

我也试过了BTSerial.print("AT");还是没有反应

Answer 1

AT 命令区分大小写，并且应该以结束符结尾，例如 enter 击键或 \r\n.

应该这样做：

#include <SoftwareSerial.h>

SoftwareSerial BTSerial(10, 11); // CONNECT BT RX PIN TO ARDUINO 11 PIN | CONNECT BT TX PIN TO ARDUINO 10 PIN

void setup()
{
  pinMode(9, OUTPUT);  // this pin will pull the HC-05 pin 34 (key pin) HIGH to switch module to AT mode
  digitalWrite(9, HIGH);
  Serial.begin(38400);
  Serial.println("Enter AT commands:");
  BTSerial.begin(38400);  // HC-05 default speed in AT command more
  BTSerial.write("AT\r\n");
}

void loop()
{
  if (BTSerial.available()) {
    Serial.write(BTSerial.read());
  }
}

Arduino 与 HC-05 连接时，串行通信无法正常工作

Serial Communication is not working properly in Arduino connection with HC-05

arduino

serial-communication

hc-05